# DIY lab food 

## Introduction
I built this because I needed a lab power supply and all the lab power supplies I could find were too expensive. This is built with 4 necessary components and the rest is optional.

## Supplies.
- SK-60 or SK-120 buck boost converter
- 60 watt usb-c pd power supply
- 4mm banana female plugs
- Wires

## Optional supplies
- XT-60 connector
- Any other connector you want to put on it

## Equipment
- soldering iron
- 3d printer
- glue gun

## Build
If you have everything it is very simple. Everything is marked on the Buck boost converter (SK-60 or SK-120) where the power goes in and where it comes out.

## Tips
- If you use this design make a cover at the top because otherwise assembly is very difficult.
- If you use an XT-60 connector make sure that the side with the corner is the ground.

## Pictures
![Foto](/md-assets/IMG_6547.jpg)
![Foto](/md-assets/IMG_6548.jpg)
![Foto](/md-assets/IMG_6549.jpg)
![Foto](/md-assets/IMG_6550.jpg)
![Foto](/md-assets/IMG_6551.jpg)
![Foto](/md-assets/IMG_6552.jpg)